Danish Audio ConnecT. High quality audio parts. Danish Audio ConnecT (DACT) is a manufacturer of High-End Audio Parts for Hi-Fi, A/V and Pro-Audio. DACT products are used by audio and A/V audio equipment manufacturers and by DIY audiophiles throughout the world. DACT audio components include stepped audio attenuators, audio balance controls, audio input selector switches,  2-channel phono stage / RIAA preamplifier modules, 2-channel line stage / linear preamplifier  modules, and audio power supplies.

DACT logo

DACT Newsletter issue 1, May 1st 2001.

Welcome to the first issue of the DACT Newsletter.

This issue of the Newsletter is distributed because there has just been published a remarkable review of different DACT products in the very respected US audiophile magazine The Absolute Sound. The review was written by Dan Sweeney and published in the April/May 2001 issue of The Absolute Sound. The review describes Dan Sweeney’s experiences with a completely DACT-based preamplifier using the CT100 phono stage, the CT101 line stage, two mono CT1 stepped attenuators and a CT3-5-4 input selector switch.
DACT has purchased the rights to publish the complete review at http://www.DACT.com, as we believe it contains valuable information about our products. The review may be found here.

Here are a few examples of what Dan Sweeney’s wrote:

“ I don’t know if the Dact preamp is the best solid-state example of the category on the market, but I’d like to see anything that touches it for under seven or eight grand.”

And

. . . . . ” So why would you do this? Well, I own three phono sections: an old Stax SR-14; an older Sumiko; and a Boulder L3AE. The latter is far superior to the first two, though it lacks flexibility, and the Dact is superior to it. The L3AE, available on special order, is about $3,700, while the Dact assemblage under review costs approximately $2,000. These facts say a great deal for it’s design integrity.” . . . . . .

And

. . . . . “ Similarly, tape hiss assumes The Dact utterly lacks the usual solid-state blemishes: grain; hardness in the treble; an overall fatiguing quality. I normally prefer tube phono stages for their sweetness and musicality, but I don’t know of one I’d substitute for this. The Dact doesn’t sound like a tube circuit but then, it doesn’t sound like much of anything. Other than conveying an incredible sense of transparency, wide dynamics, and ultra-low noise, it doesn’t seem to impart a signature of it’s own and isn’t that what we’re after?” . . . . .


Best regards
DACT